Mineral Alloy
What Mineral Alloy Actually Looks Like
Mineral Alloy reads as a grounded, medium-depth blue-gray, somewhere between a steel blue and a cloudy slate. It is not light enough to feel airy, and not dark enough to feel dramatic, which puts it in a useful middle range that works hard on walls, cabinetry, and trim alike. The color has a composed, almost industrial quietness to it.
Mineral Alloy Undertones
The hex and RGB values place this color in distinctly cool territory. The blue channel dominates over the red, which means any warm light in a room will temper it slightly toward a softer gray, while cool north light will push it bluer and steelier. In low north light it can read almost like a weathered metal. In warm incandescent or candlelight it softens and loses some of its cool edge.
Where Mineral Alloy Works Best
This color works well in rooms where you want a settled, focused atmosphere without going full dark. Home offices, primary bedrooms, and bathrooms are natural fits because the cool tone feels calm rather than cold at this depth. On cabinetry it holds up well because the LRV is low enough to give contrast against lighter walls. It also reads well on exterior trim and siding in climates with strong natural light, where it picks up more blue and less gray.
Where to put Mineral Alloy
In a bedroom, Mineral Alloy creates a quiet, restful atmosphere. Keep bedding and textiles in warm whites or natural linens so the room does not tip too cool, and add wood furniture to anchor the warmth.
The focused, slightly muted quality of this color works in a home office because it does not compete for attention. Pair it with warm wood shelving and good task lighting so the space stays energized without feeling cold.
On bathroom walls, Mineral Alloy plays up the water reference in its name. White tile and chrome fixtures reinforce the clean, cool look, while brushed brass fittings warm it up if you want less severity.
At this depth, Mineral Alloy gives kitchen or bathroom cabinetry a strong presence without going as dark as navy or charcoal. It reads as sophisticated against both white and stone countertops.
What to Pair With Mineral Alloy
No coordinating colors are listed in our database for Mineral Alloy 1622. As a general guide, it pairs well with warm off-whites to balance its coolness, with deep charcoal blues for a tonal scheme, and with natural wood tones and aged brass or copper hardware that counteract its steel character.
You Might Also Like
Colors that clash with Mineral Alloy
Mineral Alloy's cool blue-gray undertone sits directly opposite warm yellows and oranges on the color wheel. Bringing in honey-gold walls or terracotta accents in the same space creates an unsettled contrast rather than a complementary one.
Pairing this color with a stark cool white on trim can make both colors look washed out or vaguely dingy, because there is not enough contrast in temperature or value to separate them cleanly.
Common questions
Mineral Alloy has an LRV of 28.46, which puts it firmly in the medium-dark range. Colors below 25 are generally considered dark, and those above 50 read as light, so this one sits on the deeper end of medium. It will noticeably darken a room compared to a typical wall color, but it is not so dark that it requires careful lighting management the way a true near-black would.
The Benjamin Moore code is 1622. The hex and RGB values are displayed in the color spec block on this page.
Yes, Mineral Alloy 1622 is available in both interior and exterior formulas across Benjamin Moore's finish lines. For walls, a matte or eggshell finish will keep the color looking soft and grounded. On cabinetry or trim, a semi-gloss will add some reflectivity and slightly brighten the appearance.
It depends on your light. In cool north-facing light or on overcast days it reads noticeably blue and steely. In warm afternoon light or under incandescent bulbs it pulls back toward a straightforward medium gray. Neither reading is wrong; just sample it in the actual room and light conditions you have before committing.